3-10.ELECTRICAL ADJUSTMENT BY REMOTE
COMMANDER
By using Remote Commander (RM-Y909K),all circuit adjust-
ments can be made.
NOTE : Test Equipment Required.
1. Pattern Generator (with component outputs)
2. Frequency counter
3. Digital multimeter
4. Audio oscillator
1. METHOD OF SETTING THE SERVICE ADJUSTMENT MODE
SERVICE MODE PROCEDURE
1. Standby mode. (Power off)
2. DISPLAY n 5 n VOL (+) n TV POWER
on the Remote Commander.
(Press each button within a second.)
SERVICE MODE ADJUSTMENT
Data
Item NO.
Category
3D-COMB
0
0
SERVICE
NRMD
TV
WSL : XXX
Adjustment Item
F / A FLAG : XXXXXXXX
CBA FLAG : XXXXXXXX
3. The SCREEN displays the item being adjusted.
4. Press 1 or 4 on the Remote Commander to select the
adjustment item.
5. Press 3 or 6 on the Remote Commander to change the data.
6. Press 2 or 5 on the Remote Commander to select the
category.
Every time you press 2(Category up), Service mode changes
in the order as shown below.
MID3
3D-COMB
2150D-2
MID5
2103-1
2150D-3
OSD
2103-2
2151
SNNR
2150P-1
AP
ID-1
2150P-2
TRUS
CCD
2150P-3
DLBY
PJE
2150P-4
MID1
OP
MID2
2150D-1
ID
KP-HW51K90J/HW57K90J
RM-Y909K
RM-Y909K
7. If you want to recover the latest values press - then [ENTER] to
read the memory.
8. Press [MUTING] then [ENTER] to write into memory.
9. Turn power off.
Note: Press 8 then [ENTER] on the Remote Commander to initialize
or turn set off and on to exit.
2. MEMORY WRITE CONFIRMATION METHOD
1. After adjustment, turn power off with the remote commander.
2. Turn power on and set to Service Mode.
3. Call the adjusted items again and confirm they were adjusted.
3. ADJUSTING BUTTONS AND INDICATOR
MUTING
TV POWER
DISPLAY
DISPLAY
Category up
Adjustment item up
Adjustment item down
Data up
Data down
Category down
VOLUME +
ENTER
RM-Y909K
Note : When the PJE mode is activated, which displays an inter-
nally generated signal, several buttons on the remote
commander will have different functions than listed above.
Therefore, when in the PJE mode, refer to page 26 for
button functions.
Page 14