Download  Print this page

Fan Operation - Honeywell HT350 Series Owner's Manual

Oscillating table fan
Hide thumbs

Advertisement

15. Do not operate if the fan housing is
damaged.
16. A loose fit between the AC outlet (recep-
tacle) and plug may cause overheating
and a distortion of the plug. Contact a
qualified electrician to replace loose or
worn outlet.
17. Do not operate any fan with a damaged
cord or plug. Discard any damaged fan,
return the fan to the retailer where the
fan was purchased, or request a return
FUSED SAFETY PLUG - FOR US ONLY
Thank you for your purchase.
This fan features a fused safety plug which is designed to cut off electric current to the fan if an
electrical fault occurs. Please see below for more information on how to properly use your fan and
replace the safety plug fuse, if needed.
USER SERVICING INSTRUCTIONS
• Grasp plug and remove from the receptacle or other outlet device.
Do not unplug by pulling on cord.
• If your fan loses power and you suspect that the fuse on your fan
has blown, you should first remove the spare fuse holder attached
to the cord plug (Fig. 1). Remove the spare fuse from the plastic
spare fuse holder, and set the spare fuse aside (Fig. 2).
• You can gain access to the blown fuse by sliding open the door
found on the side of the plug. Slide the door outward until the
blown fuse is fully visible (Fig. 3).
• Carefully remove the blown fuse and snap the replacement fuse
into place. Risk of fire. Replace fuse only with 2.5 Amp, 125 volt
fuse (provided with product). Fully close the fuse door by sliding
back into place. Discard the blown fuse. The plug should now be
ready for normal use.
• Risk of fire. Do not replace attached plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attached
plug is damaged.
• If you need further information on how or when to replace the
fuse in the safety plug, please contact Kaz Consumer Relations
Department by visiting our website at www.kaz.com or calling
1-800-477-0457.
2
authorization to return to Kaz USA, Inc.
for examination and/or repair.
18. Do not run fan cord under carpeting. Do
not cover cord with throw rugs, runners,
or similar coverings. Do not route cord
under furniture or appliances. Arrange
cord away from traffic areas and where it
will not be tripped over.
WARNING: To Reduce The Risk of Fire or
Electric Shock, Do Not Use This Fan With
Any Solid-State Speed Control Device,
other than the one supplied.
Fig. 1
Fig. 2
Fig. 3
HT350 SERIES FAN OPERATION

FAN OPERATION

FAN OPERATION
Model HT350
On/Off
To turn fan on, press the Power button ( ) located on the left side of the control panel.
Sound Level/Speed Control
The fan will automatically start on the"Sleep" level when initially turned on. To adjust the speed
up or down, press the Fan button ( ) repeatedly to increase level.
Oscillation
To activate the Oscillation feature, press the Oscillation button ( ) once. Press the Oscillation
button again to turn the Oscillation off.
HT450 SERIES FAN OPERATION
On/Off
To turn fan on, press the Power button ( ) located on the left side of the control panel.
Speed Control
The fan will automatically start on "Sleep" speed when initially turned on. To adjust the speed up
or down, press the Fan Speed button ( ) repeatedly to increase level.
Model HT450
3

Advertisement

loading

  Related Manuals for Honeywell HT350 Series

This manual is also suitable for:

Ht450 series