2-60 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Antirattle Spring [A]
Dust Seals [B] and Fluid Seals [C]
Rubber Friction Boots [D]
Bleed Valves [E] and Rubber Caps [F]
Rear Caliper Assembly
Tighten the bleed valve.
Torque - Rear Caliper Bleed Valves: 7.8 N·m (0.80 kgf·m, 69
It is recommended that the fluid seal (piston seal) which
is removed, be replaced with a new one.
Replace the dust seals [A] if they are damaged.
Install the fluid seal [B]. Either side of the seal may face
Install the antirattle spring [A] in the caliper as shown.
Apply brake fluid to the cylinders, pistons, and fluid seals
(piston seals), and push the pistons into the cylinders by
hand. Take care that neither the cylinder nor the piston
skirt gets scratched.
Replace the caliper holder shaft rubber friction boot [A]
and dust boot [B] if they are damaged.
Apply a thin coat of silicone or PBC grease to the caliper
holder shafts [C] and holder holes (Silicone or PBC
grease is a special high temperature, water-resistance
Install the pads (see Rear Brake Pad Installation in the
Spark Plug Replacement
Fuel Tank (see Fuel Tank Removal in the Fuel System
Spark Plug Caps [A]
Remove the spark plug using the 16 mm (0.63 in.) plug
Special Tool - Spark Plug Wrench, Hex16: 57001-1262
manuals search engine