TRIP Meter Inspection
Turn the display [A] into TRIP.
During the speedometer inspection with an oscillator, ver-
ify that the trip meter reading increases.
Stop the short wave form, press the reset button more
than 2 seconds and check that the display shows "0.0".
If they are any problem, replace the speedometer assem-
Fuel Level Gauge Inspection
Connect the terminals in the same way as in the LCD
Connect a variable rheostat [A] to the terminal  and
battery negative wire as shown.
Check that the position of the gauge pointer matches the
resistance value of the variable rheostat.
Resistance values are standard and they have tolerance.
If this indicator function does not work, replace the
LED and Indicator Light Inspection
Connect the 12 V battery to the meter terminals in the
same way as in the LCD segment inspection.
FI Indicator LED Light Connections
Battery Negative Wire (–) to Terminal 
Connect the terminal .
The FI indicator LED light lights.
Disconnect the terminal .
The FI indicator LED light disappears.
If there is any problem, replace the speedometer assem-
Position of Meter Pointer
manuals search engine
ELECTRICAL SYSTEM 16-71