Brake Lever, Brake Pedal
Brake Pedal Installation
Apply grease to the brake pedal shaft.
Install the brake pedal [A] so that the punched mark on the
pedal is aligned [B] with the punched mark on the brake
Brake Pedal Return Spring
Brake Switch Return Spring
Torque - Brake Pedal Clamp Bolt: 25 N·m (2.5 kgf·m, 18
Footboard Bracket Bolts: 34 N·m (3.5 kgf·m, 25
Rear Master Cylinder Mounting Bolts: 25 N·m (2.5
Replenish the fluid in the reservoir, and bleed the brake
line (see Brake Line Bleeding).
Check the brake for proper braking power, no brake drag,
and no fluid leakage.
Do not attempt to ride the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake will
not function on the first application of the pedal if
this is not done.
Check the brake pedal position and adjust it if necessary.
Check the rear brake light switch operation and adjust
the switch if necessary (see Brake Light Switch Operation
Inspection in the Periodic Maintenance chapter).
kgf·m, 18 ft·lb)
manuals search engine