Install the rear wheel so that the grove [A] of the caliper
bracket fit onto the swingarm stop [B].
Reduce the jack until the rear axle install easily.
Engage the drive belt [A] with the pully [B].
Insert the axle from the left side of the rear wheel.
Torque - Rear Axle Nut: 108 N·m (11.0 kgf·m, 79.7 ft·lb)
Rear Caliper Mounting Bolts: 34 N·m (3.5 kgf·m,
If the axle nut is not securely tightened, an unsafe
riding condition may result.
Insert a new cotter pin [A].
When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle, tighten the
nut clockwise [B] up to next alignment.
It should be within 30 degree.
Loosen once and tighten again when the slot goes past
the nearest hole.
Bend the cotter pin [A] over the nut as shown.
Visually inspect the tire for stuck any grease.
If any grease have stuck to the surface of the tire, wash
the tire clean with soap and water solution.
Check the rear brake effectiveness.
Do not attempt to ride the motorcycle until a full
brake pedal is obtained by pumping the brake pedal
until the pads are against the disc. The brake will
not function on the first application of the pedal if
this is not done.
manuals search engine