Fuel Tank Installation
Read the above WARNING.
Route the hoses correctly (see Cable, Wire and Hose
Routing section in the Appendix chapter).
For California model, note the following:
To prevent the gasoline from flowing into or out of the
canister, hold the separator perpendicular to the ground.
Connect the hoses according to the diagram of the sys-
tem. Make sure they do not get pinched or kinked.
Route hoses with a minimum of bending so that the air or
vapor will not be obstructed.
Check that the rubber dampers [A] are in place.
If the dampers are damaged or deteriorated, replace
Pull [A] the joint lock [B] fully as shown.
Insert the fuel hose joint [A] straight onto the tank outlet
Push the joint lock [C].
Push and pull [A] the hose joint [B] back and forth more
than two times and make sure it is locked and doesn't
Make sure the hose joint is installed correctly on the
delivery pipe by sliding the joint, or the fuel could
If it comes off, reinstall the hose joint.
Connect the fuel pump, meter and the fuel level sensor
connectors and the battery (–) lead terminal.
manuals search engine
FUEL SYSTEM (DFI) 3-123