Oxygen Sensor-not activated (#1, #2: Service Code 33, 83)-Europe Models
Oxygen Sensor #1: Service Code 33
Oxygen Sensor #2: Service Code 83
Oxygen Sensor Removal/Installation
Refer to Oxygen Sensor Removal and Installation in the
Electrical System chapter.
Oxygen Sensor Inspection
The oxygen sensor itself is the same for #1 [A] and #2
[B], but wiring of the main harness side is different.
Warm up the engine thoroughly.
Turn the ignition switch OFF.
Remove the right side cover (see Right Side Cover Re-
moval in the Frame chapter).
Connect a digital voltmeter [A] to the each oxygen sensor
connector [B] (sensor side), using the needle adapter set.
Special Tool - Needle Adapter Set: 57001-1457
Oxygen Sensor Output Voltage
Connections to Oxygen Sensor Connector
Meter (+) → BK lead
Meter (−) → GY lead
Remove the air switching valve hoses [A] (both sides)
from the fittings.
Install the suitable plugs [A] (both sides) on the fittings
and shut off the secondary air.
Turn the ignition switch ON.
Start the engine, and let it idle.
Measure the output voltage of the sensor with the con-
Oxygen Sensor Output Voltage (with Plugs)
0.45 ∼ 2.5 V
manuals search engine
FUEL SYSTEM (DFI) 3-73