Omnitron Systems Technology Universal DIN Rail Mounting Bracket 8250-0 User Manual

UniDIN
DIN Rail Mounting Bracket Kit for
FlexPoint ™ and
OVERVIEW
The Omnitron Universal DIN Rail Mounting Bracket model 8250-0 is designed
to provide DIN Rail mounting capabilities for the FlexPoint converter, FlexPoint
converter with DC Adapter, iConverter
chassis. This kit contains all the necessary components to provide DIN Rail
mounting for several different mounting orientations.
Figure 1. Pre-assembled Configuration - Mounting Orientation [B]
MOUNTING ORIENTATIONS
This diagram illustrates a converter in four different DIN-Rail mounting orientations.
As shipped from the factory, the UniDIN is ready to be used in configuration [B].
[A]
[B]
[C]
Figure 2. Mounting Orientations
Model: 8250-0
™
iConverter ® User Manual
® Stand-Alone and iConverter 1-module
[D]
PACKAGE CONTENTS
Item i
(2) DIN Rail Bracket (2) DIN Rail Bracket Hex
Halves (Pre-assembled) Nuts (Pre-assembled)
Item m
(2) DIN Rail Clip Screws (4) Bracket Mounting
(Pre-assembled) Screws (In separate bag)
ASSEMBLY AND MOUNTING INSTRUCTIONS
STEP 1. Adjusting Bracket Width
If bracket width adjustment is necessary, loosen the hex nuts ( j ) on the DIN
Rail bracket ( i ) and align the DIN Rail bracket width to match the width of the
media converter. After adjusting the DIN Rail bracket to the desired width,
tighten the hex nuts ( j ) to lock the DIN Rail bracket width.
Rear Cover Screw
Front Cover
Screw
Figure 3. Adjusting Bracket Width to Match Width of Media Converter
Item j
(2) DIN Rail Clips
(Pre-assembled)
Item n
User Manual
i
j
i
Converter
Item k