Care And Cleaning - Kenwood JKP300 series Instructions Manual

3 Plug in and switch on. The indicator
light will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
Note - To interrupt the boiling
ensure that the switch is in
the off position before
removing from the power
base.
If you experience problems
G
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
Your kettle is fitted with a filter to
G
hold back limescale particles.
If you find drops of water under your
G
kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
G
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.

care and cleaning

Before cleaning, unplug your kettle
G
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
G
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
Even though your kettle comes with
G
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Open the lid. Press the lid release
button .
2 Remove the filter by holding the tab
and then lifting the filter out.
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Replace the filter by locating the
front of the filter into the spout area
and then clip into place
descaling
Regular descaling of the flat element
G
will improve the performance of your
kettle. If the kettle is not descaled
regularly the build up of limescale
may result in the following:
problems may be experienced
G
with the kettle switching on and
off during use or switching off
before boiling.
the kettle may take longer to boil.
G
the flat element may be damaged.
G
Please note: Failure to descale your
kettle may invalidate your guarantee.
When limescale starts to build up on
G
the heating element, buy a suitable
descaler and descale your kettle.
After descaling, boil with fresh water
several times and discard. Clean any
descaler off the kettle - it can
damage the parts.
Some regions of the country have
G
chalky water. This makes boiled
water look cloudy and leaves a
deposit on the side of the kettle. This
is normal but can be removed with
regular cleaning.
Alternatively, to reduce limescale
G
build up, use filtered water to fill your
kettle.
service and customer
care
If the cord is damaged it must, for
G
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
using your appliance or
G
servicing or repairs
G
Contact the shop where you bought
G
your appliance.
Designed and engineered by
G
Kenwood in the UK.
Made in China.
G
3
.