Installing The Driver Software - Pioneer XDJ-AERO Connection Manual

Using the XDJ-AERO as the VirtualDJ Pro 7
controller/audio output device

Installing the driver software

Install this unit's driver software onto the computer from the CD-ROM included with this unit.
For installation instructions, see "Installing the driver software" in the XDJ-AERO's operating instructions.
Connecting this unit and the computer
With this unit's power turned on, connect this unit and the computer using a USB cable.
VirtualDJ Pro 7 settings
1
Open the Settings screen.
Launch VirtualDJ Pro 7, then click the [CONFIG] icon.
2
Make the audio output routing setting.
Click [Sound Setup].
1
Select as shown below from the [Sound card:] pull-down menu.
2
Select as shown below from the [Outputs:] pull-down menu.
3
To use this unit's mixer section to mix the sound:
To mix the sound internally in VirtualDJ Pro 7:
3
Set up the options.
Click the [Options] tab.
1
Click [Tooltips] and select [Disable].
2
¢ ¤ £ ¥ § ¦ © ¨  ¨           ! " ¨   ¤ ¥ # % $ % £ ¥
¢ ¤ £ ¥ § ¦ © ¨  ¨           ! " ¨   ¤ ¥
  & ( ' 0 ) 2 1 0 3  4 " 5 0 6 8 7 9 1 A @ C B § D E   & ( ' 0 ) F B G 3  4 " 5  6 H 7 P I Q @ E ¡
R S 6 ( T V U W & Y X H 4 " 5 0 6 8 7 ` 1 a @  B P D E b ¤ & ( 6 ( c H d ( 5 0 e 8 7  & ( T S 4 " 5 0 6 8 7 § I ( @ f ¡
¡