Pure Cycle Tm (Wf220*) - Samsung WF210 series User Manual

cleaning and maintaining your washer
PURE CYCLE
Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the Power button.
2. Press the Pure Cycle
• You can only use the Delay Start
function.
3. Press the Start/Pause button.
• If you press the Start/Pause
button, Pure Cycle begins.
• The required time for the Pure Cycle is determined by the temperature of the supplied water.
In general, if hot water is supplied, the Pure Cycle will take approximately 2 hours.
• Using Pure Cycle, you can clean the drum without using a cleansing agent.
• Never use Pure Cycle when laundry is in the washing machine. This may cause damage to
CAUTION
the laundry or a problem with the washing machine.
• If you want to use drum cleansing agent, use only 1/10 of the amount of the drum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder-type cleansing agent , remove the liquid detergent compartment.)
The Pure Cycle Auto Alarm Function
• If the "Pure Cycle" button is lit after a wash, it indicates that
tub (drum) cleaning is required. In this case, remove the
laundry from the washing machine, turn the power on, and
clean the drum by running Pure Cycle.
• If you do not run Pure Cycle, the "Pure Cycle" indicator
turns off. However, the "Pure Cycle" indicator will light again
after two washes. Not running Pure Cycle at this point will
not cause a problem with the washing machine.
• Although generally, the Pure Cycle Auto Alarm appears once
a month or so, the frequency may differ depending on the
number of times the washing machine is used
28_ cleaning and maintaining your washer
WF210AN-02832A-08_EN.indd Sec7:28 WF210AN-02832A-08_EN.indd Sec7:28
TM
(WF220*)
TM
button.
2012-07-27 2012-07-27 4:37:07 4:37:07