12
SERVICE WORK ON THE CHASSIS
12.14
Adjusting the play of the steering head bearing
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
»
If there is noticeable play present:
–
Adjust the play of the steering head bearing.
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. There
400738-11
should be no perceptible detent positions.
»
If detent positions are noticeable:
–
Adjust the play of the steering head bearing.
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
(EXC EU/AU)
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
102280-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
(Six Days)
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
602755-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
p. 52)
. Remove screw
.
.
M20x1.5
.
M8
.
M8
. Remove screw
.
.
M20x1.5
.
M8
.
M8
(
p. 63)
(
p. 63)
p. 52)
12 Nm
(8.9 lbf ft)
17 Nm
(12.5 lbf ft)
Loctite
®
243™
17 Nm
(12.5 lbf ft)
12 Nm
(8.9 lbf ft)
17 Nm
(12.5 lbf ft)
Loctite
243™
17 Nm
®
(12.5 lbf ft)
63