Canon LBP251dw Settings Manual page 6

3
Select <Menu> in the Home Screen.
• LBP253x
Press and tap <Menu>.
• LBP252dw/LBP251dw
Press on the operation panel.
4
Select <Network Settings>.
If a screen appears prompting you to enter a System
Manager PIN, enter the correct PIN using the numeric keys,
and select <Apply>.
5
Select <Wireless LAN Settings>.
En
6
Read the message that is displayed, and select
<OK>.
7
Select <SSID Settings>.
8
Select <Select Access Point>.
SSID Settings
Select Access Point
Enter Manually
9
Select a wireless LAN router.
If multiple matched SSIDs are displayed, select the ID that
is listed first (the one with the strongest signal).
1 0
Enter the network key that you have written down.
Enter the network key using the numeric keys, and select
<Apply>.
WEP Key (5-26 Characters)
XXXXXXXXXXXXX
A/a/12 #
1 1
Select <Yes>.
6
A
Apply
1 2
After the <Connected.> screen is displayed, wait
until the Wi-Fi indicator stops blinking and turns on.
1 3
Wait approximately 2 minutes after the
connection.
IP address is set during this period of time.
When an error message appears:
Select <OK> to close the screen, check whether the
network key is correct, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
e-Manual "When an Error Message Appears"
To set IP address manually:
e-Manual "Connecting to a Wireless LAN"