• SEPHB series: If heater is used to heat volatile material, an auxiliary temperature control, sensing the contents of the vessel, should be used to avoid overheating the material.
PRIOR TO INSTALLATION Read and understand this entire manual before operating this electric heater. 1. Check for suspected damage to the heating blanket like rips, punctures, etc. 2. Verify surface to be heated is free from all sharp edges, weld splatter, rust, oil, etc.
Installation of heater using factory supplied Pressure Sensitive Adhesive (PSA): 3. Peel off the release fi lm [Figure A] and then press the heater onto the surface of the item being heated using a medium to hard rubber roller [Figure B]. Ensure blanket is making intimate contact with the surface to be heated.