Changing The Machine Operation Mode - Canon MG6400 series Online Manual

Changing the Machine Operation Mode

If necessary, switch between various modes of machine operation.
The procedure for configuring Custom Settings is as follows:
1. Make sure that the machine is on, and then select Custom Settings
from the pop-up menu on the Canon IJ Printer Utility
Note
If the computer is unable to communicate with the machine, a message may be
displayed because the computer cannot access the function information that was
set on the machine.
If this happens, click Cancel to display the most recent settings specified on your
computer.
2. If necessary, complete the following settings:
Ink Drying Wait Time
You can set the length of the machine rest time until printing of the next page begins.
Moving the slider to the right increases the pause time, and moving the slider to the
left decreases the time.
If the paper gets stained because the next page is ejected before the ink on the
printed page dries, increase the ink drying wait time.
Reducing the ink drying wait time speeds up printing.
Display Guide Message
Displays a guide when you perform operations in which the paper setting procedure
is complicated.
Hagaki Printing
Displays the guide message before the machine begins hagaki printing.
To hide the guide messages starting from the next execution of other than
plain paper printing, select the Do not show again check box in the displayed
dialog.
To display the guide messages again, display the Canon IJ Printer Utility pop-
up menu, select Custom Settings, and then check the Hagaki Printing check
box.
Important
With Mac OS X v10.8 or Mac OS X v10.7, you cannot use Display Guide
Message.
204