Canon MX530 series Online Manual page 481

Security settings Screen
• Enable
Selecting Enable allows you to choose either of the security modes below.
◦ Mode 3 (recommend)
This mode is activated on link level enforced security.
The passkey will be required when a Bluetooth device communicates with the printer. Normally
select this mode.
◦ Mode 2
This mode is activated on service level enforced security.
The passkey will be required when printing through the Bluetooth communication.
After setting the security mode, we recommend making a trial print through Bluetooth communication.
If printing does not start, change the security mode and try again.
Setting a passkey will prevent unwanted access from other Bluetooth devices. You can change the
passkey on the Passkey screen.
• Disable (Default setting)
When you register the printer, you are not required to input a passkey.
Passkey Screen
When you select Enable on the Security settings screen, you are required to set a passkey to register
the printer on other Bluetooth devices.
After you change the passkey, you may be asked to input the passkey on the Bluetooth devices you were
able to print from before the passkey was changed. In this case, input the new passkey.
481