Panasonic CS-W7DKE Service Manual page 40

CS-W7DKE CU-W7DKE / CS-W9DKE CU-W9DKE / CS-W12DKE CU-W12DKE
Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
I ndoor Unit I ndoor Unit
Front panel
Air filter
Airflow direction louver
Discharged air
Outdoor Outdoor Unit
Air inlet
(side)
Remote Control Remote Control
Operation mode
Powerful operation
Quiet operation
Timer setting
Clock setting
Troubleshooting
G Operation delayed for few minutes after restart.
G Sound like water fl owing during operation.
G Mist emerges from indoor unit.
G Noisy during operations.
G Remote control/display does not work.
G The unit cannot operate.
G Outdoor unit emits water/steam.
Ionizer
Do not touch
during operation
Unit
Air inlet (rear)
Air outlet
LCD display
Air intake
Supersonic air
purifying device
Auto OFF/ON
button
Receiver
Indicator
POWER TIMER QUIET POWERFUL ION SUPER
ALLERU-BUSTER
Transmitter
Off/On
Ion operation
Temperature setting
Fan speed selection
Airflow direction
adjustment
Memory reset
➤
This is a normal self protection control.
➤
Caused by refrigerant fl ow inside.
➤
Condensation effect due to cooling process.
➤
Installation work could be slanted or front panel didn't close properly.
➤
Check whether batteries are correctly inserted or need replacement.
➤
Check either circuit breaker is tripped, power plug is inserted correctly or
timer is used correctly.
➤
Condensation or evaporation happens at piping surface.
40
I About
Remote Control Preparation
1. Pull out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
5. Press again to confi rm
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be
recycled or disposed of
properly.
Remote Control Signal
• Make sure it is not obstructed.
• Maximum distances: 10m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Auto OFF/ON Button
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Operation
Action
mode
Automatic
Press once
Operation
Press until "beep" Cooling
sound Operation
• To OFF, press again the Auto OFF/
ON button.
• To switch the remote control signal
receiving sound off or on.
1. Press until "beep" sound and
release.
2. Press again until "beep-beep"
sound and release.
3. Press to switch the sound off or
on.
(Long "beep" - OFF; short "beep"
- ON)