Control Pads On The Dehumidifier; Control Pads - Keystone KSTAD507A Owner's Manual

CONTROL PADS ON THE DEHUMIDIFIER

NOTE: The control panel of the unit you purchased may be slightly different according to the
models.
Clean filter
indicator light
Comfort dehumidifying
operation on
indicator light
Fig.1

Control pads

When you push the button to change
operation modes, the unit will make
a beep sound to indicate that it is
changing modes.
COMFORT Pad(optional)
1
Press to activate the comfort dehumidifying operation.
NOTE: On this operation,the unit can not be set
humidity level.
2
FILTER Pad
The check filter feature is a reminder to clean the
Air Filter for more efficient operation. The Filter
light(Clean filter l ight) will illuminate after 250 hours
of operation. To reset after cleaning the filter, press
the Filter pad and the light will go off.
CONTINUE Pad
3
Press to activate the c ontinuous dehumidifying operation.
Continuous
operation on
Auto defrost operation
indicator light
on indicator light
Auto defrost
1 2
Bucket full
High fan
indicator light
indicator light
Full
On
Off
3 4
4
TURBO Pad
Control the fan speed. Press to select either High
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set
the fan control to Normal.
Timer Pad
5
Press to initiate the Auto start and Auto stop feature,
in conjuction with the
6
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the
percent value(%).
For damper air, press the
percent value(%).
TIMER Set Control Pads
Use the Up/Down pads to set the Auto
start and Auto stop time from 0.0 to 24.
7 Power Pad
Press to turn the dehumidifier on and off.
4
8
Timer on/off
indicator light
5 6 7
and key pads.
: Up/Down Pads
pad and set to a lower
pad and set a higher