Table Of Contents - Kenwood CD-2260M Service Manual

CD-2260M/2280M/DPF-J7010/J9010
QQ
3 7 63 1515 0
Contents
CONTENTS / ACCESSORIES ...................................2
EXTERNAL VIEW .......................................................3
DISASSEMBLY FOR REPAIR....................................4
CONTROLS ................................................................5
CIRCUIT DESCRIPTION ............................................7
ADJUSTMENT ..........................................................10
Accessories
Audio cord ....................... (1)
(E30-0505-05)
Remote control unit ........ (1) *
(A70-1174-08) : RC-P0506
(A70-1175-08) : RC-P0306
Battery cover (A09-0374-08)
TE
L 13942296513
Beware of condensation
When water vapor comes into contact with the surface of cold
material, water drops are produced.
If condensation occurs, correct operation may not be possible,
or the unit may not function correctly.
This is not a malfunction, however, and the unit should be dried.
(To do this, turn the POWER switch ON and leave the unit as it
is for several hours.)
Note related to transportation and movement
Before transporting or moving this unit, carry out the following op-
eration:
1. Remove all discs from the carousel and close the door panel.
2. Confirm that the flashing "NO DISC" display has changed to steady
lighting, and then switch off the power.
NO
www
3. Wait a few seconds, then disconnect the power plug.
.
2
CONTENTS / ACCESSORIES
System control cord ........ (1)
(E30-2816-05)
Batteries (R6/AA) ............ (2)
D I S C
x ao
y
i
8
PC BOARD ...............................................................11
SCHEMATIC DIAGRAM ...........................................15
EXPLODED VIEW ....................................................26
PARTS LIST..............................................................28
SPECIFICATIONS ......................................Back cover
Communication cord ....... (1)
(E30-2861-05)
* Refer to parts list on page 28.
Q Q
3 6 7 1 3
Beware of condensation
Be especially careful in the following conditions:
• When the unit is brought from a cold place to warm place, and
there is a large temperature difference.
• When a heater starts operating.
• When the unit is brought from an air-conditioned place to a
place of high temperature with high humidity.
• When there is a large difference between the internal tempera-
ture of the unit and the ambient temperature, or in conditions
where condensation occurs easily.
Operation to reset
The microcomputer may malfunction (impossibility to operate,
erroneous display, etc.) when the connection cords are un-
plugged while power is ON or due to an external factor. In this
case, execute the following method to reset the microcomputer
and return it to normal condition.
Unplug the power cord from the power socket and plug the
power cord into the socket again.
To reset the registered contents
u163
The registered contents for title name, music type, and best
selection can be reset by the following procedure.
.
Unplug the power cord from the power socket and, while
holding the 7 key depressed, plug the power cord into the
socket again.
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
9 9
2 8 9 9