IBM ThinkPad A30 Hardware Maintenance Manual page 55

Symptom or error
0195
Security hardware tamper
detected.
0196
Security hardware removed.
0197
Invalid Remote change
requested.
01C8
More than one modem devices
are found — Remove one of
them. Press Esc to continue.
01C9
More than one Ethernet devices
are found — Remove one of
them. Press Esc to continue.
0200
Hard disk error — The hard
disk is not working.
021x
Stuck key — Keyboard error.
0220
Monitor type error — Monitor
type does not match the one
specified in CMOS.
0230
Shadow RAM error — The
shadow RAM failure at offset
nnnn.
Symptom-to-FRU index
FRU or action, in sequence
1. Enter IBM BIOS Setup
Utility by entering
supervisor password, and
select "Password" -->
"IBM Security Chip" -->
"Clear IBM Security Chip"
to clear this error.
2. Security chip.
3. System board.
1. Enter IBM BIOS Setup
Utility by entering
supervisor password, and
select "Password" -->
"IBM Security Chip" -->
"Clear IBM Security Chip"
to clear this error.
2. Security chip.
3. System board.
The remote configuration for
the security chip has failed.
Confirm the operation and try
again.
1. Remove either a Mini PCI
modem card or an modem
daughter card, otherwise
press Esc to ignore the
warning message.
2. System board.
1. Remove either a Mini PCI
Ethernet card or an
Ethernet daughter card,
otherwise press Esc to
ignore the warning
message.
2. System board.
1. Reseat the hard-disk
drive.
2. Load Setup Defaults in IBM
BIOS Setup Utility.
3. Hard-disk drive.
4. System board.
Run interactive tests of the
keyboard and the auxiliary
input device.
Load Setup Defaults in IBM
BIOS Setup Utility.
System board.
ThinkPad A30, A30p
49