Table of Contents
Advertisement
•
BBV TX400
•
Pelco
5.1.5 Exit Menu
Leave the menu by going LEFT out of all levels until you leave the menu. Alternatively, use
the same key combination that was used to enter the menu. The menu will also exit
automatically if not used for 5 minutes.
All changes made will be saved permanently when the menu has been exited. The message
"Saved OK" will flash up on the screen to confirm this
The various branches of the menu system are described below. These may differ slightly
depending on the version of firmware installed in the dome.
5.2 Login
Once you have entered the menu system, go RIGHT to enter the login screen. The login
screen allows you to enter a password to gain access to other menus.
Use RIGHT and LEFT to move the cursor and UP and DOWN to change the digits. When
you have entered the password, go LEFT repeatedly to exit the login screen. A message will
appear on the screen to indicate whether you have successfully logged in, and with what
access rights (User, Supervisor or Installer).
Password levels:
User
111100
Supervisor
222200
Installer
333300
Once logged in, you remain logged in for 5 minutes from last use of the menu, even if you
exit and re-enter the menu. If you want to log out more quickly to prevent unauthorised
access, just enter an invalid password (e.g. 000000).
The login screen also displays this information about the dome:
•
Brand
•
Model
•
Serial Number
•
Firmware revision
•
Alarm module firmware revision (if fitted)
•
Protocol & Baud Rate
•
Dome address
Page 24
-
Press WASH
-
Enter 97 then press and hold PRESET key
Advertisement
Table of Contents
