Lamp - Dell M409WX User Manual

LAMP

Using the Lamp menu, you can adjust the display settings of your projectors. The
Picture menu, provides the following options:
minutes. However, you can set this to 5 minutes, 15 minutes, 30 minutes, 45
minutes, 60 minutes, or 120 minutes.
If an input signal is not detected during the delay period, the projector turns off
the lamp and goes into power saving mode. If an input signal is detected when
projector is in power saving mode, the projector automatically turns on. If an input
signal is not detected within two hours, the projector switches from Power Saving
mode to Power Off mode. To turn on the projector press the Power button.
E M —Select On to use the projector at a lower power level (168 Watts).
CO ODE
Operating at lower power levels may provide longer lamp life, quieter operation,
and dimmer luminance output on the screen. Select Off to operate at normal
power level (212 Watts).
L R —After you install a new lamp, select Yes to reset the lamp timer.
AMP ESET
Q S
UICK HUTDOWN
Power button. This function allows the projector to cool down within a short
period of time by accelerating the fan speed.
NOTE:
during power off.
26 Using Your Projector
Downloaded From projector-manual.com DELL Manuals
—Select Yes to turn off the projector with a single press of the
If Quick Shutdown is enabled, expect a slightly higher acoustic noise
L H —Displays the
AMP OUR
operating hours since the last
lamp timer reset.
P S —Select Yes to
OWER AVING
set the Power Saving delay
period. The delay period is
the time you want the
projector to wait without an
input signal. By default, the
delay period is set to 120