Anti-Lock Brake System (Equipped Models)
Remove the seats (see Rear/Front Seat Removal in the
Ground the self-diagnosis terminal [A] (Gray) to the
ground terminal [B] (Black/Yellow), using a lead.
Turn on the ignition switch.
Count the blinks of the light to read the service code.
Keep the auxiliary lead ground until you finish reading the
Service Code Clearing Procedures
Start the service code erase mode with the following pro-
The erase mode starts when the ABS self-diagnosis ter-
minal is disconnected from the ground terminal after start-
ing the self-diagnosis mode.
The service code can be erased by grounding and un-
grounding (each time for at least one second) the ABS
self-diagnosis terminal three times or more within about
12.5 seconds after starting the erase mode.
The ABS indicator light (LED) remains lit during the erase
After erasing, the ABS indicator light (LED) blinks and
Once erasing is finished, enter the self-diagnosis mode
again to confirm that the service codes have been
erased. If the ABS has been reset and all codes have
been erased, the ABS indicator light (LED) lights.