Complete Installation - Maytag pav2300agw Use & Care Manual And Installation Instructions

6. Be certain to keep cardboard spacer centered between doors. Reattach outer door panel
to inner door panel so handle is on the side where hinges were just removed.
7. Attach door hinges to dryer door so that the larger hole is at the bottom of the hinge.
8. Remove door strike (E) from cabinet. Use a small, flat-blade screwdriver to gently remove
4 hinge hole plugs (F) on left side of cabinet. Insert plugs into hinge holes on right side of
cabinet.
9. Insert screws into bottom holes on left side of cabinet. Tighten screws halfway. Position
door so large end of door hinge slot is over screws. Slide door up so screws are in bottom
of slots. Tighten screws. Insert and tighten top screws in hinges.
10. Remove door strike plug (B). Insert the door strike you removed in Step 8 into hole and
secure with screw. Insert door strike plug into original door strike hole and secure with
screw.
11. Close door and check that door strike aligns with door catch (C). If it is needed, slide door
catch left or right within slot to adjust alignment.
12

Complete Installation

1. Check that all parts are now installed. If there is an extra part, go back through the steps to
see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check the dryer's final location. Be sure the vent is not crushed or kinked.
5. Check that the dryer is level. See "Level Dryer."
6. Turn on power.
7. Remove the blue protective film on the console and any tape remaining on the dryer.
8. Read "Dryer Use."
9. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.
10. Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
Controls are set in a running or "On" position.
Start button has been pushed firmly.
Electrical supply is on.
Household fuse is intact and tight, or circuit breaker has not tripped.
Dryer door is closed.
11. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If
you feel heat, cancel cycle and close the door.
If you do not feel heat, turn off the dryer and check the following:
Check that the fuse is intact and tight, or that the circuit breaker has not tripped. If the
problem continues, contact a qualified technician.
NOTE: You may notice a burning odor when the dryer is first heated. This odor is common
when the heating element is first used. The odor will go away.