Installation - Electrolux EMM20007 User Manual

28 www.electrolux.com

10. INSTALLATION

10.1 General Information
• The microwave is for built-in use only. It
must be placed on a stable and flat
surface.
• Put the microwave far away from
steam, hot air and water splashes.
• If the microwave is to close to the TV
and radio it may cause interference in
the received signal.
• If you transport the microwave in cold
weather, do not activate it immediately
after the installation. Let is stand in the
room temperature and absorb the
heat.
10.2 Electrical installation
This microwave is supplied with a main
cable and main plug.
The cable has an earth wire with an
earthing plug. The plug must be plugged
into an outlet that is properly installed and
earthed. In the event of an electrical short
WARNING!
Refer to Safety chapters.
CAUTION!
Do not block the air vents. If
you do that, the appliance
can overheat.
CAUTION!
Do not connect the appliance
to adapters or extension
leads. This can cause
overloading and risk of fire.
CAUTION!
The minimum installation
height is 85 cm.
WARNING!
Only a qualified person must
do the electrical installation.
The manufacturer is not
responsible if you do not
follow the safety precautions
from the chapter "Safety
Information".
circuit, earthing reduces the risk of electric
shock.
10.3 Installing the microwave
1. Check if the dimensions of the
furniture meet the installation
distances.
C
D
A
B
Installation distances
Dimension
A
B
C
D
2. If the cabinet depth is over 300 mm,
put the template on the bottom of
cabinet and check if it fits. If yes, mark
the spots for screws. Remove the
template and fix the bracket with the
screws.
Skip this step if the
cabinet depth is 300 mm.
mm
380 + 2
560 + 8
300
18