Effects Of Dirty Or Defective Camera Lens Protection Window - Nokia RM-596 Service Manual

Hide thumbs Also See for RM-596:
Table of Contents

Advertisement

RM-596
Camera Module Troubleshooting
the fault is probably in the camera window. Check the window by looking carefully through it when replacing
the module. As references Figure "Good image taken indoors" and Figure "Good image taken outdoors" can
be used. Another possibility is to use a service point comparison phone, if available.

Effects of dirty or defective camera lens protection window

The following series of images demonstrates the effects of fingerprints on the camera protection window.
Note:
The effects of any dirt in images can vary very much; it may be difficult to judge if the window
has been dirty when some image has been taken or if something else has been wrong. That is why
the cleanness of the protection window should always be checked and the window should be wiped
clean with a suitable cloth.
Bright point light sources might cause images that have flares around the light source if the protection
window is dirty. A smeared fingerprint may be hard to see on the protective window but if will affect the
image quality. These flares can be avoided by cleaning the window with a suitable cloth.
Issue 2
Figure 39 Image taken with clear protection window
Figure 40 Image taken with greasy protection window
COMPANY CONFIDENTIAL
Copyright © 2010 Nokia. All rights reserved.
Page 5 – 13

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

N8-00L4L3

Table of Contents