Canon VIXIA HF R32 Quick Manual page 273

Place the camcorder on a table or
similar surface and then use the Wi-Fi
functions, as shown in the illustration
on the left.
Operating modes:
IIAVCHD]I cv. .. II
MP4
Ill
·~
II
Cl
I
If your wireless router has a WPS button, setup will be easy and all
automatic. Some wireless routers that support WPS do not have a
dedicated button but use a PIN code instead. For setup using a PIN
code, you will need to know in advance how to activate the wireless
router's WPS function.
1 Press [· ..
~rB]
to set the camcorder to playback mode and then
press
(HOME) .
2 Set up a new connection point.
6•
ll
[(<y>) Wi-Fi] •) [Wi-Fi Setup] •) [Network Setup] •) Desired
V
connection point ([(<y>) 1] to [(<y>) 3])
•>
[Set Up New]* •)
[WPS: Button] or [WPS: PIN Code], depending on whether
your wireless router has a WPS button or uses a PIN code
*
To replace the settings of an existing connection point, touch [Edit] instead and
then manually change the settings. To delete the settings, touch [Delete] and
then [Yes].
• You can set up up to three connection points for infrastructure mode
([{<y>) 1] to [(<y>) 3]). Once set up, you can use the same Wi-Fi network
without any further settings.
3 WPS button setup: Press and hold the WPS button on your
wireless router.
WPS PIN code setup: After a PIN code appears on the
camcorder's screen, enter it into your wireless router's setup
screen.
In most cases, the wireless router's setup screen is accessed using
your Web browser. For details about how to activate the Wi-Fi
protected setup, refer to the instruction manual of your wireless router.
4 Within 2 minutes, touch [OK] on the camcorder's screen.
You can touch [Stop] and then [OK] to interrupt the Wi-Fi Protected
Setup while it is in progress.
5 Touch [Automatic] to automatically obtain an IP address.
• To assign the IP address manually, touch [Manual] and perform the
procedure in To manually assign an IP address below.
• A screen to test the settings will appear.
6 Select whether to test the settings.
• You can touch [Check Current Configuration] to review the network
settings.
I
• If you touched [Yes], a test of the settings will be performed and a
confirmation screen will appear. Touch [OK].
7 Save the settings of the connection point.
fJ
[Yes]
•>
[OK]*
•>
[X]
* After touching [OK], you can review the network settings. Touch [Wi-Fi Setup]
t)
[Check Current Configuration]
t) Desired connection point ([(<t>) 1] to
[(<t>) 3]) t) [T] or [.A.] t)
[~]three
times when finished.
Congratulations! You have connected your camcorder to the access
point on your Wi-Fi network. You can now use the camcorder's conve-
nient Wi-Fi features. The general requirements for each feature are out-
lined in the next section. For more details, refer to the full-version
Instruction Manual (PDF file).
•7