Table of Contents
Advertisement
To connect to an amplifier/receiver equipped with 5.1-channel inputs
The unit supports the linear PCM multichannel format of DVD AUDIO and can feed multichannel audio output signals
from the 6 analog AUDIO OUT jacks.
It is also equipped with the DTS and Dolby Digital and MPEG Multichannel decoders. So you can enjoy any type of the
high quality surround sounds by connecting the unit to an amplifier/receiver equipped with the 5.1-channel inputs.
Connect the unit
supplied audio cables.
The unit
SUBWOOFER
PCM / STREAM
OPTICAL
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on units.
NOTE
• When using the 5.1-channel outputs of the unit, set the "DOWN MIX" in the "PREFERENCE 2" on-screen display to "OFF" and
select "5.1 CH." or "EXPERT" in the "SPK.SETTING" on-screen display. If the "EXPERT" is selected, you can control the audio
output balance of the speakers (see pages 58 and 59).
Downloaded From DvDPlayer-Manual.com JVC Manuals
s analog AUDIO OUT jacks to the analog 5.1-channel inputs of an amplifier or receiver using the
'
CENTER
RIGHT
LEFT
REAR
VIDEO
COMPONENT
RIGHT
LEFT
Y
P
FRONT
COAXIAL
S-VIDEO
DIGITAL OUT
AUDIO OUT
VIDEO OUT
Audio/Video
(supplied)
Audio cable
(supplied)
AV COMPU LINK
VIDEO OUT
SELECT
P
B
R
NTSC
PAL
White
cable
Yellow
Red
White
Audio cable
Red
(supplied)
White
Red
Getting started
Amplifier or receiver
AUDIO IN
FRONT
LEFT
RIGHT
REAR
LEFT
RIGHT
CENTER
SUBWOOFER
19
Advertisement
Table of Contents
