Table of Contents
Advertisement
Safety Warnings and Precautions
Power Supply and Power Cord
●
●
Warning
●
●
●
●
●
●
5
• Place the printer in a location that meets the specified ranges of temperature and
humidity. If the printer is either too cold or too hot, it may not operate normally.
Operating environment: 15 – 30°C (59 – 86°F)
• To ensure normal operation of the printer and avoid possible damage, never
install the printer near large office equipment or any other type of electrical
device that emits a strong magnetic field.
• Never block the ventilation ports on the printer.
A blocked ventilation port could cause heat to
build up inside the printer and cause a fire. Also,
place the printer in an area where you can
disconnect the power cord immediately; keep
the area around the power cord connection free
of obstacles. This allows you to unplug the
power cord quickly in an emergency.
To avoid causing a fire or serious electrical shock, always use the power cord
provided with this printer.
To avoid a fire or electrical shock, do not use an extension cord.
To avoid a fire or serious electrical shock, connect the printer power cord to an
independent power source that is not shared by other equipment or appliances.
To avoid causing a fire or serious electrical shock, make sure that the power plug is
securely and completely inserted into the power source.
Do not cut, damage, or otherwise alter the power cord. To avoid the dangers of fire
and electrical shock, never place a heavy object on the power cord, never expose it
to heat, and never pull on the cord to disconnect it. If the power cord is damaged in
any way (condensation on exposed wires, broken wires, etc.) contact the dealer
where you purchased the printer or the nearest service center for a replacement.
To avoid personal injury from an electrical shock, never handle the power cord or
plug when your hands are wet.
To avoid a fire or serious electrical shock, never knot the power cord or wrap it
around itself.
Disconnect the printer power cord during severe electrical storms. Lightning could
cause a fire or severe electrical shock or damage to the printer.
RH 10 – 80% (with no condensation)
Advertisement
Table of Contents
