4
Disassembly/Assembly > Image Forming System > Removing the Registration Unit > Procedure
CAUTION :
At Installation, Make Sure to Hold the Shaft [1] of the Transfer Roller and be Careful Not
to Touch the Sponge Part [2] of the Roller.
[1]
[2]
4
Disassembly/Assembly > Image Forming System > Removing the Registration Unit > Procedure
Preparations (TYPE I)
■
1) Removing the Right Cover.(Refer to page 4-23)
2) Removing the Left Cover.(Refer to page 4-19)
3) Removing the Controller Cover.(Refer to page 4-55)
4) Removing the Left Rear Cover.(Refer to page 4-22)
[1]
5) Removing the ADF + Reader Unit.(Refer to page 4-33)
6) Removing the Upper Cover Unit.(Refer to page 4-28)
7) Removing the All-night Power PCB Mount.(Refer to page 4-59)
Preparations (TYPE II)
■
1) Removing the Right Cover.(Refer to page 4-23)
2) Removing the Left Cover.(Refer to page 4-19)
F-4-230
3) Removing the Controller Cover.(Refer to page 4-55)
4) Removing the Left Rear Cover.(Refer to page 4-22)
5) Removing the ADF + Reader Unit.(Refer to page 4-33)
6) Removing the Upper Cover Unit.(Refer to page 4-28)
■
Procedure
1) Remove the Gear [1].
1 Claw [2]
•
Removing the Registration Unit
[1]
[2]
4-96
F-4-231
4-96