JVC KW-AVX706 Instructions Manual page 423

Menu items
Fader/Balance
Adjusts fader
Adjust balance
Volume Adjust
Subwoofer
High Pass Filter
Crossover
Amplifi er Gain
Rear Speaker*
Mono
DX / Local
SSM
* 11 This subwoofer level setting take effects only when surround is deactivated (
* Functions only when Dual Zone is activated.
12
* 13 Items listed under <Mode> vary among the playback sources.
Selectable settings, [reference page]
Adjust fader—speaker output balance between the front and
rear speakers.
• Upmost—front only
• Downmost—rear only
When using a two-speaker system, set the fader to the center
(00).
Adjust balance—speaker output balance between the left and
right speakers.
• Leftmost—left only
• Rightmost—right only
Adjust and store auto-adjustment volume level for each
source, comparing to the FM volume level. The volume level
will automatically increase or decrease when you change the
source.
• –12 to +12; Initial 00
Adjust the settings below in the submenu:
• Phase: Subwoofer phase. Select either "Normal" or
"Reverse," which reproduces a better sound.
• Level*
Through: Select when the subwoofer is not connected.
On:
Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
80Hz, 120Hz, 150Hz
You can change the maximum volume level of this receiver.
Off :
Low Power:
High Power:
You can activate/deactivate the rear speakers.
12
Off, On
Only for FM. (Off, On),
Only for FM. (DX, Local),
Only for FM.
: Subwoofer output level. Level: –6 to +8; Initial 0
11
Select when the subwoofer is connected.
Deactivates the built-in amplifier.
VOL 00 to 30 (Select this if the maximum
power of the speakers is less than 50 W)
VOL 00 to 50
☞
[10]
☞
[11]
☞
[11]
43
☞
also page 41).
SETTINGS