7. Monitor the RSSI value in the Tuning Lock Summary field (see figure below).
8. CW test result > RSSI reading > The RSSI value should be within limits given in the following table.
CW test result > RSSI reading ("Signal Quality" feature is not needed).
Frequency in the table is typed in DVB-H Test/Frequency field. Set signal generator frequency always 1 MHz higher.
Galvanic DVB-H RF test measurement with FS-51
Setup: PC/Phoenix/FLS-5/SS-46/FS-51 with integrated galvanic RF/SMA connector + signal
Page 6 –8
Table 14 Setup and target test values
Copyright © 2008 Nokia. All rights reserved.