Page of 234
Download Table of ContentsContents Print This PagePrint Bookmark
RM-247
BB Troubleshooting and Tuning Guide
Steps
1.
Place the phone to the docking station adapter (CU-4 is connected to the adapter).
Phoenix service software.
2.
Start
3.
Choose File→ Scan Product.
4.
Choose Tuning→Energy Management Calibration.
5.
To show the current values in the phone memory, click Read, and check that communication between
the phone and CU-4 works.
6.
Check that the CU-4 used check box is checked.
7.
Select the item(s) to be calibrated.
Note:
ADC calibration has to be performed before other item(s). However, if all calibrations are
selected at the same time, there is no need to perform the ADC calibration first.
8.
Click Calibrate.
The calibration of the selected item(s) is carried out automatically.
The candidates for the new calibration values are shown in the
calibration values seem to be acceptable (please refer to the following "Calibration value limits" table),
click Write to store the new calibration values to the phone permanent memory.
Parameter
ADC Gain
ADC Offset
BSI Gain
VBAT_SCAL Gain
VBAT_SCAL Offset
IBAT Gain
9.
Click Read, and confirm that the new calibration values are stored in the phone memory correctly. If the
values are not stored to the phone memory, click Write and/or repeat the procedure again.
10. To end the procedure, close the
Issue 1
Table 12 Calibration value limits
Min.
13000
-14
1100
21000
2450
7750
Energy Management Calibration window.
COMPANY CONFIDENTIAL
Copyright © 2008 Nokia. All rights reserved.
Calculated values column. If the new
Max.
13350
14
1300
21900
2570
12250
Page 3 –71

   Also See for Nokia N96

This manual also for:

L3, L4

Comments to this Manuals

Symbols: 0
Latest comments: