Enter The Network Settings; Set The Profile Name; Set The Essid (Manual); Set The Essid (Ap Scan) - NEC UX5000 Easy Setup Manual

2.1.1.6

Enter the Network Settings

The following program steps are made from the Config menu (see Place the MH240 in Config
Mode (page 2-2)), then enter the Profile to be edited:
2.1.1.6.1
2.1.1.6.2
2.1.1.6.3
Chapter 2
1. Go to "Config" menu. (See "PLACE THE MH240 IN CONFIG MODE")
2. Press 1 (Network Setting) + 1 (Profile) to view Profile Select menu.
▲
3. Press to select a profile you want to edit and then press the "OK" soft key.
▼

Set the Profile Name:

Factory Default: 1.NEC-SETUP (2 to 9 are blank)
1. Within the desired Profile within the Config menu, at the Profile Setting screen,
press 1 (Wireless Setting) + 1 (Profile Name) to go to the Profile Name edit
screen.
2. Edit the name of the Service Profile you created on the WL1700 (Refer to 2.1.1.4
Keypad Character List on page 2-2.) and then press the "OK" soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.

Set the ESSID (Manual):

✎
Select either Manual or AP Scan. For AP Scan, skip the Manual steps
below.
Factory Default: NEC-setup (1.NEC-SETUP)
1. If Manual is required, press 2 (ESSID) + 1 (Manual) to go to the ESSID edit
screen.
2. Enter the name of the ESSID provided and then press the "OK" soft key.
3. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.

Set the ESSID (AP Scan):

✎
Select either Manual or AP Scan. For Manual Scan, skip the AP Scan steps
below.
Factory Default: -
1. If AP Scan is required, press 2 (ESSID) + 2 (AP Scan) to scan AP and then view
Scanned ESSID list. The ESSID will be the one broadcast by the Access Point
(AP).
▲
2. Press to select ESSID you want to connect and then press the "OK" soft key.
▼
3. Press HOLD to back up the menu view.
4. Continue with the next feature or press the Power/On-Hook key and 2 to save.
Pressing the Power/On-Hook key and 1 will cancel any entered changes.
Chapter 2 - MH240 Setup
2 - 3