Projecting An Image (Basic Operation); Turning On The Projector - NEC NP4001 User Manual

3. Projecting an Image (Basic Operation)

Turning on the Projector

Once the projector is correctly located and the power cable and other connections are in
place, it is important that the projector is powered on correctly in order to avoid damage to
components and unnecessary wear and tear. Refer to the following guide to power on the
projector.
1.
Connect the power cable (A).
Press the main power switch ( I )
to the on position as shown (B).
The power LED lights orange.
2.
Press the On/Standby button
once (see
Status LEDS on page 8). The
power LED lights green and the
internal cooling fan starts.
3.
After approximately 10 seconds,
the power LED flashes intermit-
tently green.
4.
The Lamp1 and Lamp2 LEDs
light green and the Power LED
flashes more rapidly.
5.
Once the power LED is lit
solidly green, the projector is
ready for use.
Note:
If any of the LEDs remain flashing or blink there may be a problem with the startup.
Please refer to the
Downloaded From projector-manual.com NEC Manuals
O SD Controls and
3
Troubleshooting section on page 112.
A
37
B