Assembly Instructions - Kärcher HD 3.0/30 Pb Operator's Manual

Handle
Alignment
Holes
Frame
Assy.
STEP 1: Attach the handle to the
frame of the pressure washer. Note:
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
Safety
Latch
High Pressure
Hose
STEP 4: Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
High Pressure Hose
Discharge
STEP 7: Connect high pressure
hose to pump discharge fitting.
Push coupler collar forward until
secure.
STEP 9: Connect the garden hose to pump water inlet.
Inspect inlet screen. CAUTION: Do not run the pump
6 without water or pump damage will result.

ASSEMBLY INSTRUCTIONS

Carriage
Bolt
STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
Spray
Gun
STEP 5: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
Cold
Water
Source
Coupler
Collar
Pump
Garden
Fitting
Hose
STEP 8: Connect garden hose to a
clean cold water source and open
supply valve completely. NEVER
use hot water.
Garden
Hose
Inlet Screen
Pump
Water Inlet
9.807-623.0 • Rev. 10/15
Nut
Washer
Pressure
Nozzle
Wand
Coupler
Bolts Hose/Spray Gun
Storage Bracket
Nut
Studs
STEP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
Pressure
Wand
Nozzle
Coupler
Wand
Collar
STEP 6: Release the coupler col-
lar and push the nozzle and the
collar until the collar clicks or locks.
Pull the nozzle to make sure it is
secure.