Pioneer DDJ-RZ Operating Instructions Manual page 27

Setting the audio data output from this unit to
the computer
When rekordbox is running and using this unit as the default audio device, set the
audio data output in rekordbox.
Display the setting utility before starting.
1 Click the [CONTROLLER OUPUT] tab.
2 Click the [DDJ-RZ Audio Output] pull-down menu.
Select and set the audio data to be output to the computer from the flow of audio
signals inside this unit.
CH1 (USB1/2) CH2 (USB3/4) CH3 (USB5/6)
CH3 Control
— —
Tone PHONO
CH1 Control CH2 Control CH3 Control
1 1
Tone CD Tone CD Tone LINE
Post CH1 Post CH2 Post CH3
2 2
Fader Fader Fader
2 2
Cross Fader A Cross Fader A Cross Fader A
2 2
Cross Fader B Cross Fader B Cross Fader B
MIC MIC MIC
— — —
— — —
1 The audio data is output with the same volume at which it is input to this unit, regardless of
the [USB Output Level] setting.
2 When using for applications other than recording, pay attention to the DJ application's set-
tings so that no audio loops are generated. If audio loops are generated, sound may be input
or output at unintended volumes.
!
When there is a connection with rekordbox dj, the CH5 setting cannot be changed to other
than [MIX (REC OUT)].
3 Click the [USB Output Level] pull-down menu.
Adjust the volume of the audio data output from this unit.
! The [USB Output Level] setting is applied equally to all audio data. However,
when 1 on the table at step 2 is selected, the audio data is output with the same
volume at which it is input to this unit.
! If not enough volume can be achieved with the DJ software's volume adjustment
alone, change the [USB Output Level] setting to adjust the volume of the audio
data output from this unit. Note that the sound will be distorted if the volume is
raised too high.
CH5
CH4 (USB7/8)
(USB9/10)
CH4 Control MIX (REC
1 1 2
Tone PHONO OUT)
CH4 Control
Cross Fader A
1 1
Tone LINE
Post CH4
Cross Fader B
2 2
Fader
2 2
Cross Fader A MIC
Post CH1
2 2
Cross Fader B
2
Fader
Post CH2
MIC
2
Fader
Post CH3
—
2
Fader
Post CH4
—
2
Fader
Adjusting the buffer size (when ASIO is used)
This function can only be used by those using a Windows operating system.
If an application using this unit as the default audio device (DJ software, etc.) is run-
ning, quit that application before adjusting the buffer size.
Display the setting utility before starting.
Click the [ASIO] tab.
! If the buffer size is made large, drops in audio data (breaks in the sound) occur
less easily, but the time lag due to the delay in the transfer of the audio data
(latency) increases.
Checking the version of the driver software
Display the setting utility before starting.
2
Click the [About] tab.
2
27
En