LG 50PK950 Training Manual page 150

Front Control (IR and Intelligent Sensor) Board and Power LED Bo
Front Control (IR and Intelligent Sensor) Board and Power LED Bo
P100
P100
To Main
To Main
To remove P101 ribbon, using your fingernail, lift up the locking
mechanism. Slide the board out to the left to release the ribbon
cable.
To facilitate reinstallation, slide the board to the right
just enough to place a slight bow in the ribbon cable,
then using a small object, press down gently on the ribbon. When
properly seated, the ribbon will be under the two plastic tabs in the
connector.
Front IR Board
To Soft Touch
To Soft Touch
Key Pad
Key Pad
Lower Left Side (As viewed from rear).
P101
P101
150 October 2010
ard Location
ard Location
Soft Touch Key Pad
(Behind)
Thin strip adhered to
the protective front
glass.
50PK950 Plasma