Table of Contents
Advertisement
2.
Remove terminal block cover
Before you start, disconnect power. Remove hold-down screw
and terminal block cover.
ELECTRICAL CONNECTION
Power Supply Cord
Power supply cord strain relief:
1.
Attach power supply cord
strain relief
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
Remove screws from 3/4" (19 mm) UL listed strain relief (UL
marking on strain relief). Put two clamp section tabs into hole
below terminal block opening with one tab pointing up and one
pointing down. Hold in place and tighten strain relief screws
enough to hold two clamp sections together.
2.
Attach power supply cord
to strain relief
Put power supply cord through strain relief. Be sure that wire
insulation on power cord is inside strain relief. Strain relief should
be a tight fit with dryer cabinet and be in a horizontal position.
Do not tighten strain relief screws at this point.
now go to step 1 for 4-wire power supply cord connection
or step 1 for 3-wire power supply cord connection.
A
B
C
D
7
Advertisement
Table of Contents
