Table of Contents
Advertisement
2.
move dryer to final location
Move dryer to final location, taking care not to crush or kink vent.
After dryer is in place, remove corner posts and cardboard from
under dryer.
LEvEL DRYER
1.
level Dryer
Place
Place
level here
level here
Check levelness of dryer from side to side. Repeat from front
to back.
noTE: The dryer must be level for the moisture sensing system
to operate correctly.
lEVEl
Not Level
Not Level
2.
Tighten and adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness. Once
legs are level, make sure all four legs are snug against the ground
before tightening them.
W10309063B
W10309065B-SP
© 2010
All rights reserved
COMpLETE INSTALLATION
CHECKLIST
q
Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Be sure the water faucets are on.
q
Check for leaks around “Y” connector, faucet, and hoses.
q
Check dryer’s final location. Be sure vent is not crushed or
kinked.
q
Check that dryer is level. See “Level Dryer”.
q
Remove film on console and any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
q
Read “Dryer Use” in your Use and Care Guide.
q
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on Power.
q
If you live in a hard water area, use of a water softener is
recommended to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime
scale may clog different parts of the water system, which
will reduce product performance. Excessive scale buildup
may lead to the need for certain part replacement or repair.
q
Select a Time Dry heated cycle, and start dryer. Do not select
Air Only Temperature setting.
If dryer will not start, check the following:
• Controls are set in a running or “On” position.
• Start button has been pushed firmly.
• Dryer is plugged into an outlet and/or electrical supply.
• H ousehold fuse is intact and tight, or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
noTE:
You may notice an odor when dryer is first heated. This
odor is common when heating element is first used. The odor will
go away.
TROUbLESHOOTINg
See the Use and Care Guide for troubleshooting information.
3/10
Printed in U.S.A.
Advertisement
Table of Contents
