16-36 ELECTRICAL SYSTEM
Using the flywheel puller [A], remove the alternator rotor
[B] from the crankshaft.
Special Tool - Flywheel Puller Assembly, M38 × 1.5/M35 ×
Do not attempt to strike the alternator rotor itself.
Striking the rotor can cause the magnets to lose
Alternator Rotor Installation
Apply a thin coat of molybdenum disulfide grease to the
crankshaft [A] and the outer surface [B] of the starter
clutch gear [C].
Install the starter clutch gear [A].
Using a cleaning fluid, clean off any oil or dirt on the fol-
lowing portions and dry them with a clean cloth.
Crankshaft Tapered Portion [B]
Alternator Rotor Tapered Portion [C]
Fit the woodruff key [D] securely in the slot in the crank-
shaft before installing the alternator rotor.
Install the alternator rotor [A] while turning [B] the starter
clutch gear [C] clockwise.
Using a cleaning fluid, clean off any oil or dirt on the
washer [A] and dry it with a clean cloth.
Install the washer.
Confirm the alternator rotor fit or not to the crankshaft
before tightening it with specified torque.
Install the rotor bolt [B] and tighten it with 70 N·m (7.0
kgf·m, 52 ft·lb) of torque.