16-34 ELECTRICAL SYSTEM
Alternator Cover Removal
Engine Oil (see Engine Oil Change in the Periodic Main-
Air Cleaner Housing (see Air Cleaner Housing Removal
in the Fuel System (DFI) chapter)
Left Lower Fairing (see Lower Fairing Removal in the
Disconnect the alternator lead connector [A].
Clear the alternator lead from the clamp [B].
Place a suitable container under the alternator cover [A].
Open the clamp [B].
Alternator Cover Bolts [C]
Alternator Cover Installation
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket to the alternator lead grommet and
crankcase halves mating surface [A] on the front and rear
sides of the cover mount.
Sealant - Liquid Gasket, TB1211F: 92104-0004
Check that dowel pins [B] are in place on the crankcase.
Replace the alternator cover gasket with a new one.
Torque - Alternator Cover Bolts: 12 N·m (1.2 kgf·m, 106
Run the alternator lead correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Install the removed parts (see appropriate chapters).
Stator Coil Removal
Alternator Cover (see Alternator Cover Removal)
Alternator Lead Holding Plate Bolt [A] and Plate
Alternator Lead Grommet [B]
Stator Coil Bolts [C]
Remove the stator coil [D] from the alternator cover.