Anti-Lock Brake System (Equipped Models)
ABS Motor Relay Inspection (Service Code 35)
Front Seat (see Front Seat Removal in the Frame chap-
Check the ABS motor relay fuse (25 A) [A] (see Fuse
Inspection in the Electrical System chapter).
If the fuse is good, check the wiring continuity between
the positive (+) terminal [A] of the battery and R/W lead
terminal [B] in the ABS hydraulic unit lead connector [C].
If there is not the continuity in the lead, replace or repair
the main harness.
If there is the continuity in the lead, go to next step.
Recheck the service code indication; erase the service
code, perform the pre-diagnosis inspection 1 and 2, and
retrieve the service code.
If the yellow ABS indicator (LED) [A] lights, the ABS hy-
draulic unit has trouble. Replace the ABS hydraulic unit.
If the yellow ABS indicator (LED) does not light, ABS sys-
tem is normal (service code is not stored; temporary fail-
Front Wheel Rotation Sensor Signal Abnormal
(Service Code 42)
Measure the air gap between the front wheel rotation sen-
sor and sensor rotor (see Wheel Rotation Sensor Air Gap
Check the front wheel rotation sensor (see Wheel Rota-
tion Sensor Inspection).
If both inspections are good, go to next step.
Check that there is iron or other magnetic deposits be-
tween the sensor [A] and sensor rotor [B], and the sensor
rotor slots for obstructions.
Check the installation condition of the sensor for loose-
Check the sensor rotor tip for deformation or damage
(e.g., chipped sensor rotor teeth).
If the sensor rotor in bad condition, remove the any de-
posits. Install the proper part or replace faulty part.
If the all items are good, go to next step.