Anti-Lock Brake System (Equipped Models)
Yellow ABS Indicator (LED) Inspection
In this model, the yellow ABS indicator (LED) [A] goes on
or blinks by the control of the ABS hydraulic unit.
Turn the ignition switch on.
If the yellow ABS indicator (LED) lights, it is normal.
If the yellow ABS indicator (LED) does not light, refer to
the Meter Unit Inspection in the Electrical System chapter.
If the meter is good, check the wiring continuity of the Y
lead in the main harness.
Special Tool - Needle Adapter Set: 57001-1457
Wiring Continuity Inspection
Meter Connector [A] ← →
Y Lead [C]
If there is not the continuity in the lead, replace or repair
the main harness.
If there is the continuity in the lead, replace the ABS hy-
Solenoid Valve Inspection (Service Code 13, 14,
Recheck the service code indication; erase the service
code, perform the pre-diagnosis inspection 1 and 2, and
retrieve the service code.
If the yellow ABS indicator (LED) [A] light, the solenoid
valve in the ABS hydraulic unit has trouble. Replace the
ABS hydraulic unit.
If the yellow ABS indicator (LED) does not light, ABS sys-
tem is normal (service code is not stored; temporary fail-
ABS Solenoid Valve Relay Inspection (Service
Front Seat (see Front Seat Removal in the Frame chap-
Check the ABS solenoid valve relay fuse (15 A) [A] (see
Fuse Inspection in the Electrical System chapter).
ABS Hydraulic Unit