Anti-Lock Brake System (Equipped Models)
Remove the front seat (see Front Seat Removal in the
Ground the self-diagnosis terminal [A] (Gray) to the bat-
tery (–) terminal, using a suitable lead.
Turn the ignition switch on.
Count the blinks of the indicator to read the service code.
Keep the auxiliary lead ground until you finish reading the
Service Code Clearing Procedures
Start the service code erase mode with the following pro-
The erase mode starts when the ABS self-diagnosis ter-
minal is disconnected from the battery (–) terminal after
starting the self-diagnosis mode.
The service code can be erased by grounding and un-
grounding (each time for at least one second) the ABS
self-diagnosis terminal three times within about 12.5 sec-
onds after starting the erase mode.
The yellow ABS indicator (LED) remains lit during the
After erasing, the yellow ABS indicator (LED) blinks and
Once erasing is finished, enter the self-diagnosis mode
again to confirm that the service codes have been
erased. If the ABS has been reset and all codes have
been erased, only start code 12 will be shown.