5-28 ENGINE TOP END
Remove the M6 cylinder head bolts [A].
Loosen the M10 cylinder head bolts as shown sequence
[1 ∼ 10], and remove them with washers and spring wash-
Remove the cylinder head.
Cylinder Head Installation
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
Replace the cylinder head gasket [A] with a new one.
Install the dowel pins [B] and cylinder head gasket.
Replace the cylinder head bolt washers [A] and spring
washers [B] with new ones.
Apply molybdenum disulfide oil solution to the followings.
Both Side of Cylinder Head Bolt Washers
Both Side of Spring Washers
Threads of Cylinder Head Bolts
Install the cylinder head bolt washers and spring washers
to the cylinder head bolts as shown.
Tighten the M10 cylinder head bolts following the tighten-
ing sequence [1 ∼ 10].
Torque - Cylinder Head Bolts (M10):
30 N·m (3.1 kgf·m, 22 ft·lb)
54 N·m (5.5 kgf·m, 40 ft·lb)
Tighten the M6 cylinder head bolts [A].
Torque - Cylinder Head Bolts (M6): 12 N·m (1.2 kgf·m, 106
Tighten the following parts (see Engine Removal/Installa-
tion in the Engine Removal/Installation chapter).
Upper Adjusting Collar
Upper Adjusting Collar Locknut
Upper Engine Mounting Bolts
Lower Engine Bracket Bolts