Service Information; Full Two-Year Home Use Warranty - Black & Decker CCS818 Instruction Manual

3. (Figure X) Keep the correct top
plate (23) filing angle line of 30°
on your file guide parallel with
your chain (file at 60° from
chain viewed from above).
4. (Figure Y) Sharpen cutters (24)
on one side of the chain first.
File from the inside of each
cutter to the outside. Then turn
your saw around and repeat the
processes (2,3,4) for cutters on
the other side of the chain. Use
a flat file to file the tops of the
rakers (portion of chain link in front of the cutter) so that they are
about .025 inch (.635 mm) below the tips of the cutters.
5. (Figure Z) Keep all cutter
lengths equal.
6. If damage is present on the
chrome surface of the top
plates or side plates, file back
until such damage is removed.
CAUTION: After filing, the cutter
will be sharp, use extra caution
during this process.
NOTE: Each time the chain is sharpened, it loses some of the low
kickback qualities and extra caution should be used. It is
recommended that a chain be sharpened no more than four times.
X
60°
23
23
.025"
Y
.025 in.
24 .635mm
Z
Accessories
Accessories are available from your local retailer or nearest
Black & Decker service center.
Replacement chain accessory number RC800 (service part # 623382-00)
Replacement bar service part # 623381-00
WARNING: The use of accessories not recommended in this
manual may be hazardous.

Service Information

All Black & Decker Service Centers are staffed with trained personnel
to provide customers with efficient and reliable power tool service.
Whether you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location nearest you.
To find your local service location, refer to the yellow page directory
under "Tools—Electric" or call: 1-800-544-6986 or visit
www.blackanddecker.com

Full Two-Year Home Use Warranty

Black & Decker (U.S.) Inc. warrants this product for two years against
any defects in material or workmanship. The defective product will be
replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to
the retailer from whom it was purchased (provided that the store is a
participating retailer). Returns should be made within the time period
of the retailerʼs policy for exchanges (usually 30 to 90 days after the
sale). Proof of purchase may be required. Please check with the
retailer for their specific return policy regarding returns that are
beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a
Black & Decker owned or authorized Service Center for repair or
replacement at our option. Proof of purchase may be required.
Black & Decker owned and authorized Service Centers are listed
under "Tools-Electric" in the yellow pages of the phone directory.
This warranty does not apply to accessories. This warranty gives you
15