When You Move - GE TCX22 Use And Care Manual

Rollers
which enable you to move your
Adjustable rollers,
refrigerator away from the wall for cleaning, are
located behind the base grille. These rollers should be
set so the refrigerator is firmly positioned on the floor
and the front is raised just enough that the doors close
easily when opened about halfway.
To adjust rollers,
remove the base grille
by grasping it at the
bottom and pulling it
straight out.
Stabilizing Brakes
This refrigerator is equipped with additional leveling
feet which serve as stabilizing brakes. This additional
leveling foot will hold the refrigerator securely in
position during operation and cleaning. To set the
brakes, first adjust the leveling wheels to the desired
position. Second, rotate the leveling brakes until the
brakes are firmly in place against the floor. After the
brakes are securely in place, unscrew the leveling
wheels adjusting bolt counterclockwise until the
weight of the refrigerator is supported by the
stabilizing brakes. This allows the weight to be
positioned on the leveling brakes. Reverse the
procedure to roll the refrigerator out.
When you goon vacation
For extended vacations or absences,
to refrigerator, move the freezer control to OFF
position, and clean interior with baking soda solution
of one tablespoon of soda to one quart of water. Wipe
dry. To prevent odors, leave open box of soda in
refrigerator. Leave doors open.
For shorter vacations,
leave controls at regular settings. However, if room
temperature is expected to be below 60°F., follow
same instructions as for extended vacations.
Move icemaker feeler arm to STOP (up) position and
be sure to shut off water supply to
'1
shut off power
remove perishable foods and
refrigerator.
the
Turn roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Use 3/8" socket
wrench or adjustable wrench.
When adjusting the front
rollers for proper door closure,
it is recommended that the bottom front edge of
the cabinet be approximately 3/4" from the floor.
To replace base grille,
align prongs on back of
grille with slots in cabinet
and push forward until the
grille snaps into place.
Caution: To avoid possible personal injury or
property damage the stabilizing brake must
be firmly touching the floor.

When you move

Disconnect power cord from wall outlet, remove all
food, and clean and dry the interior.
Secure all loose items such as grille, shelves and
storage pans by taping them securely in place to
prevent damage.
Be sure refrigerator stays in upright position during
actual moving and in van. Refrigerator must be
secured in van to prevent movement. Protect outside
of refrigerator with blanket.
Roller Adjustment
Screws
'(@
Roller
11