Setting Up The Rdrigerator; Removing The Refrigerator Doors - Samsung rf197acrs User Manual

Hide thumbs Also See for rf197acrs:
Table of Contents

Advertisement

Settn
up your French Door Refr erator
FLOORING
For proper installation, this refrigerator must be placed on a level
surface of hard material that is the same height as the rest of the
flooring. This surface should be strong enough to support a fully
loaded refrigerator, or approximately 2231bs(106kg). To protect
the finish of the flooring, cut a large section of the cardboard
carton and place under the refrigerator where you are working.
When moving the refrigerator, be sure to pull it straight out and
return it to position by pushing it straight in.
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between it and the wall.
Refer to installation instructions in this manual. (page 9, selecting the best location for the Refrigerator)
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
[_
Checkthe accessories listed below.
Compression fitting
Compression nut
Hex Wrench
Fastener
Required
Tools
{Not provided}
Phillips screwdriver(+)
Flat-blade screwdriver(-)
Socket Wrench
(10ram) (for bolts)
REMOVING
THE REFRIGERATOR
DOORS
HI
Hex Wrench (3/16")
{for Mid hinge)
Pliers
Some
installations
require
door/drawer
removal to transport
the Refrigerator
to its final location.
Do not remove the door/drawer
if it is not needed.
Before
removing
the door/drawer
make sure you read
following
items.
A
Disconnect
power to the Refrigerator
before removing the door or drawer.
WARNING
®
,, Be careful not to drop, damage or scratch the door/drawer while removing them.
,, Be careful not to get injured while removing the door/drawer.
,, Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
10
settng
up

Advertisement

Table of Contents
loading

Table of Contents